How to Replace the Memory Module(s) | HP Z6 G4 Workstation | HP


Before you begin: Remove the access panel, riser assembly (if installed), and memory fan/duct assembly. Removal – 1. Push down and out on the memory slot latches to release the memory module. 2. Slide the memory module up and out of the memory slot and remove. Replacement – IMPORTANT: When installing the memory module, be sure to align the notch in the memory module with the key in the memory module slot in
the system board. DO NOT install the memory at an angle or in a sloping direction. It must be inserted straight into the connector. 1. Align the notch in the memory module with the key in the memory module slot on the system board and insert the memory module. 2. Press down on the memory module until the memory slot latches lock and the memory module is fully seated.

One thought on “How to Replace the Memory Module(s) | HP Z6 G4 Workstation | HP

  1. What happens if we use a 1.5V and other 1.35V memory sticks in a single motherboard… Will they bith work together or will not….?

Leave a Reply

Your email address will not be published. Required fields are marked *

Copyright © 2019 Explore Mellieha. All rights reserved.