How to Replace the VGA USB Board | HP EliteBook 840 G3 Notebook PC | HP

How to Replace the VGA USB Board | HP EliteBook 840 G3 Notebook PC | HP

How to replace the VGA USB board Caution: Observe all precautions when removing and replacing components. Before you begin: remove the base enclosure, battery, keyboard, wireless LAN module, hard disk drive, base plate frame, and system board. Removal: Remove the two 5 millimeter P1 Phillips head screws that secure the VGA USB board to the…

How to Remove and Replace the Front Bezel | HP Z8 G4 Workstation

How to Remove and Replace the Front Bezel | HP Z8 G4 Workstation

Before you begin: Remove the top bezel. Removal: On the bottom of the chassis, release the two clips that secure the front bezel to the chassis. Grasp the front bezel near the bottom and slowly pull it away from the chassis to release the remaining clips. Lift the front bezel off of the chassis and…

How to Remove and Replace the Front Bezel | HP Z4 G4 Workstation

How to Remove and Replace the Front Bezel | HP Z4 G4 Workstation

Removal On the bottom of the chassis, release the two clips that secure the front bezel to the chassis. Grasp the front bezel near the bottom and slowly pull it away from the chassis to release the remaining clips. Lift the front bezel off the chassis and remove. Replacement Toe the tabs on the upper…

How to Replace the Primary Processor and Heatsink | HP Z6 G4 Workstation | HP

How to Replace the Primary Processor and Heatsink | HP Z6 G4 Workstation | HP

Before you begin: Remove the access panel, riser assembly(if installed), and memory fan/duct assembly. Removal – IMPORTANT: When handling the processor, do not touch the processor contacts. 1. Disconnect the CPU fan cable from the system board. IMPORTANT: The heatsink has numbers adjacent to the screw holes on the heatsink. The screws must be loosened…

How to Replace the Power Connector Cable | HP ENVY 14-j000 Notebook PC | HP

How to Replace the Power Connector Cable | HP ENVY 14-j000 Notebook PC | HP

Note: The following video depicts a specific configuration of the notebook. The same removal and replacement procedures apply to all configurations of the notebook. Before you begin: Remove the base enclosure, battery, wireless module, fan, RJ-45 door, sub woofer, display panel assembly, system board. Removal – 1. Remove the 3 mm P1 Phillips-head screw that…

How to Replace the Motherboard | HP All-in-One 22 and 24 Series

How to Replace the Motherboard | HP All-in-One 22 and 24 Series

Before you begin: Remove the hinge cover, the stand, the speaker cover, and partially separate the rear cover and LCD panel assemblies. Remove the fan, the wireless LAN board, system memory, the SSD bracket and SSD module if it’s installed in the unit, the heat sink, and the GPU if it’s installed in the unit….

How to Replace the RTC Battery | HP ZHAN 66 Pro 14, 15 G3 Notebook PC | HP

How to Replace the RTC Battery | HP ZHAN 66 Pro 14, 15 G3 Notebook PC | HP

How to Replace the RTC Battery Before you begin: Remove the base enclosure, battery, and SD card reader. Removal Take the removed SD card reader board and turn it over. While holding the SD card reader board down firmly, grasp the RTC battery cable and disconnect it from the SD card reader board. Replacement Hold…

Copyright © 2019 Explore Mellieha. All rights reserved.