How to Replace the GPU/Video Card | HP All-in-One 22 and 24 Series

How to Replace the GPU/Video Card | HP All-in-One 22 and 24 Series

Before you begin: Remove the hinge cover, the stand, the speaker cover, and partially separate the rear cover and LCD panel assemblies. Remove the fan and the heat sink. Removal Detach the four Phillips #2 screws that secure the GPU to the motherboard shielding. Tip up the edge of the GPU and pull it out…

How to Replace the System Board | HP Stream x360 11-p000 Convertible PC | HP

How to Replace the System Board | HP Stream x360 11-p000 Convertible PC | HP

Note: The following video depicts a specific configuration of the notebook. The same removal and replacement procedures apply to all configurations of the notebook. Before you begin: Remove the base enclosure, battery, wireless module, and wireless WAN module(if installed). Removal – IMPORTANT: Make careful note of the routing of all cables for later replacement. 1….

How to Replace the GPU/Video Card | HP All-in-One PC 22-c0000 Series

How to Replace the GPU/Video Card | HP All-in-One PC 22-c0000 Series

To remove the GPU, first remove the hinge cover, the stand, the speaker cover, and partially separate the rear cover and LCD panel assemblies. Remove the fan and the heat sink. Detach the four Philips #2 screws that secure the GPU to the motherboard shielding. Tip up the edge of the GPU and pull it…

Disabling the Graphics Card on HP TouchSmart PCs in Windows 8 | HP Computers | HP

Disabling the Graphics Card on HP TouchSmart PCs in Windows 8 | HP Computers | HP

When your HP TouchSmart screen does not work after upgrading to Windows 8, you can disable the graphics card to get the system working correctly. This video shows how to disable the graphics card. On the Windows Start screen, type Device Manager to open the Search field. From the results, click Device Manager. In Device…

How to Replace the – M.2 Solid State Drive  | HP Z6 G4 Workstation | HP

How to Replace the – M.2 Solid State Drive | HP Z6 G4 Workstation | HP

Before you begin: Remove the access panel. Removal – 1. Loosen the T8 Torx-head screw that secures the solid state drive assembly to the chassis and allow it to release to the spring tension position. 2. Grasp the solid state drive assembly by the edges and pull gently to remove it from its slot on…

How to Replace the PCI Card Guide/Front Fan Assembly | HP Z6 G4 Workstation | HP

How to Replace the PCI Card Guide/Front Fan Assembly | HP Z6 G4 Workstation | HP

Before you begin: Remove the access panel and riser assembly(if installed). Removal – 1. Disconnect the front fan cable from the system board. 2. Press the release latch and remove the auxiliary power cable connectors from the holding slots in the PCI card guide. 3. Press the front edge of the fan assembly and pull…

Copyright © 2019 Explore Mellieha. All rights reserved.